Altitude Decompression Sickness: Tiny Bubbles, Big Troubles

January 29, 1998


by
FAA Civil Aeromedical Institute

Decompression sickness (DCS) describes a condition characterized by a variety of symptoms resulting from exposure to low barometric pressures that cause inert gases (mainly nitrogen), normally dissolved in body fluids and tissues, to come out of physical solution and form bubbles. DCS can occur during exposure to altitude (altitude DCS) or during ascent from depth (mining or diving). The first documented cases of DCS (Caisson Disease) were reported in 1841 by a mining engineer who observed the occurrences of pain and muscle cramps among coal miners exposed to air-pressurized mine shafts designed to keep water out. The first description of a case resulting from diving activities while wearing a pressurized hard hat was reported in 1869.

Altitude-induced decompression sickness

Altitude DCS became a commonly observed problem associated with high-altitude balloon and aircraft flight in the 1930s. IN present -day aviation, technology allows civilian aircraft (commercial and private) to fly higher and faster than ever before. Though modern aircraft are safer and more reliable, occupants are still subject to the stresses of high altitude flight--and the unique problems that go wit these lofty heights. A century and one-half after the first DCS case was described, our understanding of

DCS has improved, and a body of knowledge has accumulated; however, this problem is far from being solved. Altitude DCS still represents a risk to the occupants of modern aircraft.

Tiny bubbles

According to Henry's Law, when the pressure of a gas over a liquid is decreased, the amount of gas dissolved in that liquid will also decrease. One of the best practical demonstrations of this law is offered by opening a soft drink. When the cap is removed from the bottle, gas is heard escaping, and bubbles can be seen forming in the soda. This is carbon dioxide gas coming out of solution as a result of sudden exposure to lower barometric pressure. Similarly, nitrogen Is an inert gas normally stored throughout the human body (tissues and fluids) in a physical solution. When the body is expose to decrease barometric pressures (as in flying an unpressurized aircraft to altitude or during a rapid decompression), the nitrogen dissolved in the body comes out solution. If the nitrogen is forced to leave the solution too rapidly, bubbles form in different areas of the body, causing a variety of signs and symptoms. The commonly symptom is joint pain, which is known as "the bends."

Trouble sites

Although bubbles can form anywhere in the body, the most frequently targeted anatomic locations are the shoulders, elbows, knees, and ankles. Table 1 list the different DCS types with their corresponding bubble formation sites and their most common symptoms. "The Bends" (joint pain) account for about 60 to 70% of all altitude DCS cases with the shoulder being the most common site. Neurologic manifestations are present in about 10 to 15% of all DCS cases with headache and visual disturbance being the mot common symptoms. "The chokes" are very infrequent and occur in less than 2% of all DCS cases. Skin manifestation are present in about 10 to 15 % of all DCS cases.

Medical treatment

Mild cases of "the bends" and skin bends (excluding mottled or marbled skin appearance) may disappear during descent from high altitude, but still require medical evaluation. If the sign and symptoms persist during descent or reappear at ground level, it is necessary to provide hyperbaric oxygen treatment immediately (100% oxygen delivered in a high pressure chamber). Neurological DCS, "the chokes," and skin bends with mottled or marbled skin lesion (see table 1) should always be treated with hyperbaric oxygenation. These conditions are very serious and potentially fatal if untreated.

Facts about breathing 100% oxygen

One of the most significant breakthroughs in altitude DCS research was the discovery that breathing 100% oxygen before exposure to low barometric pressure (oxygen pre-breathing), decreases the risk of developing altitude DCS. Oxygen pre-breathing promotes the elimination (washout) of nitrogen from body tissue. Pre-breathing 100% oxygen for 30 minute prior to initiating ascent to altitude reduces the risk of altitude DCS for short exposures (10-30 minutes only) to altitudes between 18,000 and 43,000 feet. However, oxygen pre-breathing has to be continued, without interruption, with in-flight 100% oxygen breathing to provide effective protecting against altitude DCS.

Furthermore, it is very important to understand that breathing 100% oxygen only during flight (ascent, en route, descent) does not decrease the risk of altitude DCS, and should not be used in lieu of oxygen pre-breathing. Although 100% oxygen pre-breathing is an affective method to provide individual protection against altitude DCS, it is not a logistically simple nor an inexpensive approach for the protection of civil aviation flyers (commercial or private). Therefore, at the present time it is only used by military flight crews and astronauts for their protection during high altitude and space operations.


Table 1 -- Types of Decompression Sickness


Predisposing factors

What to do when altitude DCS occurs

Things to Remember

If you are interested in learning more about altitude DCS, as well as the other stressors that may affect your performance and/or you health during flight, we encourage you to enroll in the physiologic training course offered by the Aeromedical Education Division (Airman Education Programs) at the FAA Civil Aeromedical Institute in Oklahoma City. A similar course is also available to you at the U.S. military physiologic training facilities around the country through an FAA/DOD training agreement. For more information about any of these courses, call us at 405-954-4837.



Copyright Aviation Publishing Group. All rights reserved